How to Disassemble an Airsoft Ak
How to Disassemble an Airsoft Ak
Introduction
The G&G CM RK47 is one of the most affordable and reliable AEG's on the market and with this guide it is like shooting fish in a barrel to dissemble also.
-
-
Start by pressing the top cover servant push and lifting the top embrace off of the gun.
-
-
-
Pull the thin black rod away from the top embrace button and swing information technology outwards.
-
Remove the small spiral from the plastic receiver cover using a #0 Phillips screwdriver.
-
-
-
Lift the plastic receiver encompass from the receiver and remove it.
-
Slide the top cover retainer button out of its groove and remove it.
-
-
-
Remove the four screws on the underside of the receiver with a 2mm hex commuter.
-
Pull the barrel assembly out of the receiver.
-
Remove the two screws belongings the hop-up unit in place.
-
Pull the inner barrel out of the outer butt.
-
-
-
Remove the spiral a the lesser of the pistol grip with a #2 Phillips screwdriver.
-
Remove the two motor mount screws with a 2mm hex driver.
-
-
-
Using a apartment head screwdriver, pry off the selector lever cap.
-
One time the cap is removed, remove the screw underneath with a #2 Phillips screwdriver.
-
Remove the selector lever.
-
-
-
Advisedly remove the gearbox from the receiver, making sure that the wires don't get stuck.
-
-
-
Using a 2.5mm hex driver, remove the three screws that concur the stock to the receiver.
-
Pull the stock away from the receiver to remove it.
-
-
-
Remove the safety from the correct side of the gearbox.
-
Remove the selector gear screw with a 2mm hex driver as shown.
-
Remove the selector gear associates.
-
-
-
Lift the tabs on the small black cap behind the trigger, and and then remove the cap.
-
Pull the wires out from nether the tabs on the spring plate that runs along the top of the gearbox.
-
Advisedly remove the spring plate past tapping it gently with a plastic hammer until it slides off the front of the gearbox.
-
-
-
Remove the four remaining gearbox screws with a 2mm hex driver.
-
Hold down the cylinder with your thumb while prying the gearbox apart from the top.
-
Equally yous remove the right half of the gearbox, be sure to hold down the cylinder, piston, and spring assembly so that they exercise not pop out under tension.
-
Also continue a shut eye out for any gear shims that may dislodge themselves every bit you are taking the gearbox apart.
-
-
-
Slowly lift the bound guide out of the gearbox along with the piston spring.
-
Remove the entire piston and cylinder assembly with the tappet plate, tappet plate jump, and air nozzle.
-
Remove the trigger assembly and lift upwards the wire harness, unhooking the trigger plunger spring in the process.
-
-
-
Pull the trigger plunger out of the wire harness.
-
Remove the three gears and the anti-reversal latch. Be careful non to misplace any of the shims or bushings, or the anti-reversal latch spring.
-
-
-
The RK47 is now fully disassembled.
-
Determination
To reassemble your device, follow these instructions in reverse lodge.
Embed this guide
Choose a size and copy the code below to embed this guide as a small widget on your site / forum.
Preview
How to Disassemble an Airsoft Ak
Posted by: norristhearted.blogspot.com
0 Response to "How to Disassemble an Airsoft Ak"
Post a Comment